Term
| What TO references contain information about ground handling? |
|
Definition
| Specific aircraft technical order, AFI 11–218, TO 00–25–172 and AFOSH 91–100. |
|
|
Term
| Where do most aircraft specific TOs list the safe for maintenance precautions? |
|
Definition
| In the first couple steps of the task. |
|
|
Term
| During launch, what tasks do you accomplish after the aircraft taxis? |
|
Definition
| Police the parking area and prepare AGE for pickup |
|
|
Term
| Why should an aircraft be moved in a straight line for 5 feet after a turn? |
|
Definition
| To relieve the loads on the main landing gear. |
|
|
Term
| What organization established standard hand signals? |
|
Definition
| International Civil Aviation Organization. |
|
|
Term
| When is a safety observer positioned by a parked aircraft? |
|
Definition
| When any portion extends into an active taxiway. |
|
|
Term
| When mooring an aircraft, how do you position the aircraft in relation to the wind? |
|
Definition
| Head the aircraft into prevailing winds. |
|
|
Term
| What are the usual causes of towing accidents? |
|
Definition
| Inexperienced personnel and failure to follow correct towing procedures. |
|
|
Term
| What’s the minimum number of tow crewmembers? |
|
Definition
|
|
Term
| What must happen for towing to proceed without incident? |
|
Definition
| Each crewmember must do his or her assigned job correctly. |
|
|
Term
| What should be done before towing an aircraft taxiway holdline? |
|
Definition
Do not tow aircraft beyond taxiway hold lines or within 100 feet of an active runway if there are no hold
lines, unless previously cleared by air traffic control. |
|
|
Term
| What TO sets down the basic rules for grounding of aircraft? |
|
Definition
|
|
Term
| What are the reasons for jacking aircraft? |
|
Definition
Weigh the aircraft, change landing gear or gear component, repair landing gear or gear component, perform
a retraction check or change a tire or brake. |
|
|
Term
| What jacking accessory prevents damage to the aircraft structure? |
|
Definition
|
|
Term
| If the aircraft TO doesn’t establish it, what’s the maximum wind velocity for a jacking operation? |
|
Definition
|
|
Term
| When is anti-icing accomplished? |
|
Definition
In preparation of forecasted inclement weather to assist the deicing process by eliminating the amount of
deicing fluid needed to remove snow, ice, or frost accumulation |
|
|
Term
| What’s the most damaging action of sand and dust? |
|
Definition
| Adherence to oil-bearing surfaces |
|
|
Term
| What’s the preferred method of raising a downed aircraft? |
|
Definition
|
|
Term
| How much weight is the F–2 lifting bag designed to lift? |
|
Definition
|
|
Term
| What’s the chief limitation of using lifting bags? |
|
Definition
| They must be used for hoisting alone and never as a permanent support. |
|
|
Term
| Why are the use of cranes and lifting slings limited during crash and recovery on larger aircraft? |
|
Definition
Because of equipment availability that can carry such loads and accessibility of attachment points on the
aircraft for the crane. |
|
|
Term
| List the three characteristics of prime importance in determining supply system segments? |
|
Definition
(1) The supply system is worldwide. This suggests manageable segments on a geographic basis.
(2) Accomplishment of the supply mission depends on the performance of specialized functions such as
storage, distribution, and disposal. This suggests manageable segments on a functional basis.
(3) The system contains millions of items, which vary in size, use, complexity, and value. |
|
|
Term
| Who has responsibility for supply discipline? |
|
Definition
| All military and civilian employees regardless of grade or position |
|
|
Term
| Name some examples of bench stock items. |
|
Definition
| Nuts, bolts, cotter keys, washers, resistors, capacitors, light bulbs, sealants and batteries. |
|
|
Term
| How should operating stock be identified? |
|
Definition
Clearly identify items as “Operating Stock” and label them with noun, NSN or part number (if applicable),
unit of issue, and shelf-life, if applicable. |
|
|
Term
| What methods are used to order expendable supplies? |
|
Definition
| Over the radio, telephone, e-mail, intercom, teletype, mail, or in person. |
|
|
Term
| What are the two priority systems Base Supply uses to respond to your supply requirements? |
|
Definition
| Delivery priority and UMMIPS. |
|
|
Term
What delivery priority is assigned to primary mission air vehicles undergoing scheduled or
unscheduled maintenance? |
|
Definition
|
|
Term
| What’s the basic purpose of a QRL? |
|
Definition
To provide maintenance personnel with a speedy identification and communication capability for placing a
demand on a supply. |
|
|
Term
| What form is normally used to request expendable supplies? |
|
Definition
|
|
Term
| What form is used to request items that don’t have an NSN? |
|
Definition
|
|
Term
| What form is used as a control document whenever you loan a tool to another individual? |
|
Definition
|
|
Term
|
Definition
| An item for which valid or forecasted requirements exceed present or anticipated resources. |
|
|
Term
| When will the personnel in Base Supply order a replacement DIFM item? |
|
Definition
| When it’s determined the unserviceable item can’t be repaired on base, or the item is condemned. |
|
|
Term
| What two documents are used to control a DIFM item through the repair cycle? |
|
Definition
| DD Form 1348–1A and AFTO Form 350, Part II. |
|
|
Term
| When shop action is complete, what form is used to tag the item for turn-in? |
|
Definition
|
|
Term
| What are the two categories of supply-type items that require turn-in? |
|
Definition
|
|
Term
| Which part of the AFTO Form 350 serves as a production scheduling document? |
|
Definition
|
|
Term
| Which condition tags are easily identified by their yellow margins and letters? |
|
Definition
|
|
Term
Which DD forms are used to identify serviceable materiel that requires test, alteration,
modification, conversion, or disassembly? |
|
Definition
| The DD Form 1576 and DD Form 1576–1. |
|
|
Term
| How often is the DD Form 23 provided to the customer? |
|
Definition
|
|
Term
| What’s the purpose of the deficiency reporting? |
|
Definition
| Establish a system to identify, report, and resolve deficiencies. |
|
|
Term
Which DR category if uncorrected would cause death, severe injury or severe occupational
illness? |
|
Definition
|
|
Term
| What DR category identifies a potential enhancement? |
|
Definition
|
|
Term
| What are the three classes of acceptance inspection defects? |
|
Definition
(1) Minor/nonconformance.
(2) Major/nonconformance.
(3) Critical/nonconformance. |
|
|
Term
| What does the engine and support warranty program warrant against? |
|
Definition
| Defects in AFMC workmanship |
|
|
Term
| For how long are aircraft engines overhauled by depot facilities warranted? |
|
Definition
The first 100 hours of post overhaul operation or one year from the date of receipt by the using activity,
whichever occurs first. |
|
|
Term
| What activities may purchase warranted tools and participate in the warranted tool program? |
|
Definition
Participating activities are aircraft, missile, and munitions maintenance units in the active duty Air Force,
Air Force Reserves and Air National Guard. |
|
|
Term
| Who is responsible for government property? |
|
Definition
| All personnel working for the Air Force. |
|
|
Term
| What would happen if responsibility for property weren’t assigned? |
|
Definition
| The whole system would fall into wastefulness and uselessness |
|
|
Term
| What level of command has command responsibility for all property? |
|
Definition
| Commanders at all levels have command responsibility |
|
|
Term
| Who does individual responsibility apply to? |
|
Definition
| Any person who exercises control over Air Force property. |
|
|
Term
| What’s custodial responsibility? |
|
Definition
Responsibility, which must be assumed by an individual who has acquired physical possession of
government property. |
|
|
Term
Explain the responsibility, accountability, and ownership of an Air Force item issued to an
individual. |
|
Definition
| The individual is responsible and accountable but the Air Force retains ownership of the property. |
|
|
Term
| What’s pecuniary liability? |
|
Definition
| The person responsible must pay for the loss. |
|
|
Term
If pecuniary liability isn’t involved, what are the two ways of relieving yourself from property
responsibility? |
|
Definition
|
|
Term
| What’s meant by property transfer? |
|
Definition
| Change of physical location or user. |
|
|
Term
| During transfer of personnel, when may a custodian depart from the base? |
|
Definition
| When the custodian’s hand receipts and records are cleared. |
|
|
Term
What methods are used to relieve an individual from property responsibility when the amount
doesn’t exceed $500? |
|
Definition
| Cash collection voucher and statement of charges. |
|
|
Term
| Who prepares cash collection vouchers? |
|
Definition
|
|
Term
| Why may the cost vary when a DD Form 362 is submitted? |
|
Definition
| The individual may be allowed depreciation. |
|
|
Term
| When must a report of survey be prepared? |
|
Definition
| When an individual won’t admit liability or when the amount to be charged is over $500. |
|
|
