Term
| What Route would have the lowest administrative distance? |
|
Definition
| A directly connected network |
|
|
Term
| What command would be used to configure a static route on R1 so that traffic from both LANs can reach the 2001:db8:1:4::/64 remote network?[image] |
|
Definition
| ipv6 route 2001:db8:1:4::/64 2001:db8:1:3::2 |
|
|
Term
| What is a characteristic of the distribution layer in the three layer hierarchical model? |
|
Definition
| Provides access to the rest of the network through switching, routing, and network access plicies. |
|
|
Term
| Which three statements are generally considered to be best practives in placement of ACLs? say 3 |
|
Definition
Filter unwanted traffic before it travels onto a low- bandwidth link.
Place extended ACLs close to the source IP address of the traffic.
Place standard ACLs close to the destination IP address of the traffic. |
|
|
Term
| How is a fram sent from PCA forwarded to PCC if the MAC address table on switch SW1 is empty?[image] |
|
Definition
| SW1 floods the frame on all ports on SW1, excluding the port through which the frame entered the switch. |
|
|
Term
| Which address prefix range is reserved for IPv4 multicast? |
|
Definition
| 224.0.0.0 - 239.255.255.255 |
|
|
Term
| Which statement describes a diifference between the operation of inbound and outbound ACLs? |
|
Definition
| Inbound ACLs are processed before the packets are routed while outbound ACLs are processed after the routeing is completed. |
|
|
Term
| What are 3 primary benefits of using VLANs? |
|
Definition
| Security, Cost reduction, Improved IT staff efficiency |
|
|
Term
| What routing table entry has a next hop address associated with a destination network? |
|
Definition
|
|
Term
| Which type of InterVLAN communication design requires the configuration of multiple subinterfaces? |
|
Definition
|
|
Term
| Which two devices allow hosts on different VLANs to communicate with each other? |
|
Definition
| Layer 3 switch and Router |
|
|
Term
| What 2 ways correctly describe a router memory type and its contents? |
|
Definition
RAM is volatile and stores the IP routing table.
ROM is nonvolatile and contains basic diagnostic software |
|
|
Term
| In what switch mode should port Go/1 be assigned if Cisco best practices are being used?[image] |
|
Definition
|
|
Term
| Why does a layer 3 device perform a ANDing process on a destination IP address and subnet mask? |
|
Definition
| to identify the network address of the destination network |
|
|
Term
| which range of link-local addresses can be assigned to an IPv6 enabled interface? |
|
Definition
|
|
Term
| What are three parts of an IPV6 global unicast address? |
|
Definition
A global routing prefix that is used to identify the network portioin of the address that has been provided by an ISP.
A subnet ID that is used to identify networks inside of the local enterprise site.
An interface ID thaat is used to identify the local host on the network. |
|
|
Term
| An IPV6 enabled device sends a data packet with the destination address of FF02::2. what is the target of this packet? |
|
Definition
| All IPV6 configured routers on the local link |
|
|
Term
| A router is configured to participate in multiple routing protocol: RIP, EIGRP, and OSPF. the router must send a packet to network 192.168.14.0 Which route will be used to forward the traffic? |
|
Definition
| a 192.168.14.0/24 route that is learned via RIP |
|
|
Term
| What does the IP address 192.1681.15/29 represent? |
|
Definition
|
|
Term
| A network administrator is implementing a stateless DHCPv6 operation for the company. Clients are configuring IPv6 addresses as expected. However, the clients are not getting the DNS server address and the domain name informtaion configured in the DHCP pool. What could be the cause of the problem?[image] |
|
Definition
| The router is configured for SLAAC operation |
|
|
Term
| Match the packets with the destination IP address to the exiting Interfaces on the router.[image] |
|
Definition
|
|
Term
| Match the DHCP message tyes to the order of teh DHCPv4 process |
|
Definition
|
|
Term
Match the network with the correct IP address and prefix that will satisfy the usable host addressing requirements for each network.
[image] |
|
Definition
|
|
Term
| What is the term that is used for the area of a network that is affected when a device or network service experiences problems? |
|
Definition
|
|
Term
| As the network administrator you have been asked to implement EtherChannel on the corporate network. What does this configuration consist of? |
|
Definition
| Grouping multiple physical ports to increase bandwidth between two switches. |
|
|
Term
| Which characteristic would most influence a network design engineer to select a multilayer switch over a layer 2 switch? |
|
Definition
| ability to build a routing table |
|
|
Term
| A network administrator is planning to add a new switch to the network. what should the network administrator do to ensure the new switch exchanges VTP information with the other switches in the VTP domain? |
|
Definition
| Configure the correct VTP domain name and password on the new switch |
|
|
Term
| Switch SW-A to be used as a temporary replacement for another switch in the VTP Student domain. What two pieces of information are indicated from the exhibited output?[image] |
|
Definition
There is a rist that the switch may cause incorrect VLAN information to be sent through the domain.
This switch will update its VLAN configuration when VLAN changes are made on a VTP server in the same domain. |
|
|
Term
The network administrator configures both switches as displayed. However, host C is unable to Ping host D and host E is unable to ping Host F. What action should administrator take to enable this communication?
[image] |
|
Definition
| Configure either trunk port in the dynamic desirable mode |
|
|
Term
| What eliminates switching loops? |
|
Definition
|
|
Term
| Which switch will be elected the root bridge and which switch will place a port in blocking mode?[image] |
|
Definition
SW4 will get a port blocked
SW3 will become the root bridge |
|
|
Term
| A network administrator has configured OFPF in the topology as shown. What is the preferred path to get from the LAN network that is connected to R1 to the LAN network that is connected to R7[image] |
|
Definition
|
|
Term
| Which statement describes the autonomous system number used in EIGRP configuration on a cisco router? |
|
Definition
| It functions as a process ID in the operation of the Router |
|
|
Term
| An EIGRP router loses the route to a network. Its topology table contains two feasible successors to the same network. What action will the router take? |
|
Definition
| The best alternative backup router is immediately inserted into the routing table. |
|
|
Term
| what is a function of OSPF hello packets? |
|
Definition
| to discover neighbors and build adjacency between them. |
|
|
Term
| R1 and R2 are OSPFv3 neighbors. Which address would R1 use as the next hop for packets that are destined for the internet?[image] |
|
Definition
|
|
